-4-
In
In
Out
Out
Wiring sponge pad
1
2
3
4
Push the shaft cover clip outwards to
remove the cover.
Loosen the adjustment screw, tilt the
bracket about 45° and pass through the
wire.
Fasten the bracket to the wall.
Change the bracket direction according
to whether the Main unit is to face left
or right.
Pass the wire through the base
knockout and install the base on the
bracket.
Adjustment
screw
BRACKET INSTALLATION AND ADJUSTMENT
6
20°
20°
90°
90°
6-A
Bracket installation
Shaft cover
Push
Using the bracket makes it possible to adjust
the unit through 180° degree.
In cases where the ground is uneven and therefore not parallel with the base of the unit, it is
possible to adjust the unit vertically by +/- 20 degree (see section 6-B)
Do not change the detection
distance with bracket.
Use the masking seal to
adjust the detection distance.
Caution>>
