6
E101887#1
6.1 Designing and making the individual parts for the drivers seat, driver and arm supports etc.
6.1.1 Mark out the pine strip (2) 10 x 20 x 150mm as shown, saw into sections along the lines.
Note
:
The remaining piece (2f) may be slightly undersize due the thickness of the saw cuts.
6.1.2 Take the drivers body (2a) and chamfer the bottom to 25 degrees. Mark out and drill the 2 mm holes to fit arms
and legs. On the top drill a 10mm deep blind hole for the neck as shown in the diagram.
6.1.3 Round off the corners of the drivers head (2b) and drill a 4mm diameter x 10 deep blind hole in the top.
20,0
30,0
45,0
45,0
20,0
40,0
65,0
25°
Ø 4,0
10,0
65,0
10,0
20,0
Ø 2,0
2e
2e
2d
2f
2b
2c
2a
2a
20,0
10,0
Ø 4,0
R 4,0
2b
ca.
