Opex FalconV, User Manual

Page: 123 / 130

Statistics 123
FalconV User Manual - Standard Scanning - OPEX Corporation
Vertical Turn Sensor
Missing
Results when the controller is expecting to see a
piece pass by the vertical turn sensor but it has
not within the expected time period.
Stacker Entry Sensor
Missing
Results when the controller is expecting to see a
piece pass by the stacker entry sensor but it has
not within the expected time period.
Bin 2 Gate Sensor
Missing
Results when the controller is expecting to see a
piece pass by the bin 2 gate sensor but it has
not within the expected time period.
Feed Entry Multifeed
Sensor Blocked
The Feed Entry MultiFeed Sensor is blocked.
Feed Input Multifeed
Sensor Blocked
The Feed Input MultiFeed Sensor is blocked.
Unexpected Piece at
Stacker Entry Sensor
Results when a piece is detected at the stacker
entry sensor that the software was not
expecting. This is usually caused by a piece that
was intended to go to the stacker bypass bin but
did not make the correct decision in time. A gate
that did not fire properly can also cause it.
Unexpected Piece at Bin
2 Sensor
Results when a piece is detected at the bin 2
sensor that the software was not expecting. A
gate that did not fire properly usually causes this
to occur.
Invalid Piece Complete
Response Results when an invalid piece id is received
from the host upon piece completion.
Piece Thickness Sensor
Null Below Minimum
Results when the thickness sensor is lower than
the minimum null defined in the machine
parameters.
Piece Thickness Sensor
Null Above Maximum
Results when the thickness sensor is greater
than the maximum null defined in the machine
parameters.
Piece Thickness Sensor
Runout Problem
Results when the thickness sensor runout is
greater than the maximum runout defined in the
machine parameters.
Table 11: Reasons for jams (continued)