Opengear 9913DA-AES110-RG, User Manual

Page: 19 / 41

9913DA-AES110-RG User Manual Installation •
• •
• 2-3
Installing the 9913DA-AES110-RG
This section outlines how to install a rear module and card in a 20-slot frame. The same procedure
applies regardless of the frame or card type.
Rear Modules for the 9913DA-AES110-RG
• When installing the 9913DA-AES110-RG in the 20-slot frame, the RM20-9913DA110-B
Full Rear Module or the RM20-9913DA110-B/S Split Rear Module can be used. When
using a Full Rear Module in the 20-slot frame, use the even numbered slots, such as 2,4,6
etc. to ensure that the card aligns with the rear module.
Installing a Rear Module
If the Rear Module is already installed, proceed to the section “ Installing the 9913DA-AES110-RG ”.
Use the following procedure to install a Rear Module in a 20-slot frame:
1. Locate the card frame slots on the rear of the frame.
2. Remove the Blank Plate from the slot you have chosen for the 9913DA-AES110-RG
installation.
3. Install the bottom of the Rear Module in the Module Seating Slot at the base of the
frame’s back plane. ( Figure 2.1 )
Figure 2.1 Rear Module Installation
4. Align the top hole of the rear module with the screw hole on the top edge of the back
plane of the frame.
5. Using a Phillips driver, and the supplied screw, fasten the Rear Module to the back plane.
Do not over tighten.
6. Ensure proper frame cooling and ventilation by having all rear frame slots covered with
Rear Modules or Blank Plates.