!
Installation guide
Please make sure to use this products based on the following regulation, in order to avoid
any damage to human body or to other connected products.
Installation
Note
Before installation, please make sure:
1.Note the value range and the related mark on the product and the User Guide;
2.Make sure the power adapter specification matches with the product label
Installation Steps:
1.Connect optical fiber patch code with Media Converter fiber port. Note fiber TX on one end should be connected to
RX on the other end to Media Converter.
2.UTP wire to RJ45 port of the Media Converter. 100Base-TX requires 2 twisted pairs (1/2; 3/6), while 1000 Base-T
requires 4 twisted pairs, and it must be Super Category 5 twisted pair or Super Category 6 twisted pair.
3.Connect the power adapted DC plug with Media Converter DC plug, and then insert the AC power adapter plug to
AC socket, turn on the power, now the Media Converter POWER indictor is ON, the other indictors will be ON
successively with the self-inspection turn. The RJ45 port will detect the connected device status to decide itself
working status, if no devices are detected; Media Converter RJ45 port will be set up to be Full-duplex, which will be
displayed with the LED indictor.
1 Don’t put heavy thing on the product to keep good heat dissipation status
2 Turn off the power before plugging the power
3 Don’t look straight at the fiber ports when Media Converter is powered, in case any damage to eyes.
Please refer to the above solution with any problems of installation and using, or get in to touch with our technicians.
