HOBO RX3000 Remote Monitoring Station Manual
12
h.
Click Save. You can also click Next to move from one
smart sensor to the next.
i.
Repeat steps e–h for any additional smart sensors you
need to configure.
Wireless Sensor Configuration
You can configure both the global settings for the RXW
Manager module that affect all sensor motes (logging
interval) and the settings for each individual mote (labels,
enabled graphs, and scaling).
a.
Click Module <#>: Wireless Sensors Logging from the
menu on the left.
b.
Select the logging interval to be used for all wireless
sensors, which can be different than the one used for
smart sensors and analog sensors (if applicable).
c.
Click Save or Next.
d.
Click one of the motes from the menu under Module <#>:
Wireless Sensors Logging as shown in the following
example. Click the serial number or name for the mote,
not the measurement type.
e.
Type a label for the mote (optional) and click to enable
the battery graph for the mote if desired. The label will
also automatically be applied to any mote sensors
without a default label.
f.
Click Save or click to Next to move to either the next
mote (if it was a repeater) or the sensor measurement
type for that mote.
g.
Click one of the mote measurement types from menu
under Module <#>: Wireless Sensors Logging as shown
in the following example
h.
Type a label for the measurement type (optional) and
click to enable or disable the graph (enabled by default).
i.
To set up scaling for the wireless sensor, click the Enable
Scaling checkbox and fill in the Scaled Units, Multiplier,
Offset, and Scaled Measurement Type.
j.
Click Save or click Next.
k.
Repeat steps d–j for any additional motes you need to
configure for the module.
Analog Module and Sensor Configuration
You can configure both the global settings for the analog
module that affect all connected analog sensors (logging
interval, statistics, and excitation) and the settings for each
individual analog sensor (enabled logging and graphs,
labels, sensor type, and scaling).
a.
Click Module <#>: Analog Sensors Logging from the
menu on the left.
b.
Select the logging interval to be used for all analog
sensors, which can be different than the one used for
smart sensors and wireless sensors (if applicable).
c.
Click the Enable checkbox under Sampling Interval if you
want to log statistics. Enter the sampling interval to be
used for calculating the statistics (must be a factor of
the logging interval). Select the statistics to be logged:
www.
.com
1.800.561.8187
