ONLINE ELECTRONICS LTD
3015_5001_A01
Page 15 of 17
5.2.
ROUTINE MAINTENANCE AND STORAGE
All Online Electronics Ltd transmitters are designed to require minimum maintenance. The
housing should be cleaned using fresh water and cleaning agents as necessary (e.g. WD40).
Do not use chemicals which could be damaging to the housing or O-rings.
Check flame paths / threads on the housing body and endcaps for signs of corrosion or
damage. If badly pitted or damaged, replace the relevant component.
All components that are replaced must be in accordance with the manufacturers’ specifications.
Failure to use such components may invalidate the certification/approval and may make the
equipment dangerous.
Online Electronics Ltd can supply redress kits containing a complete set of replacement
batteries, O-rings, O-ring grease, battery discs and endcap locking screws, contact Online
Electronics Ltd for more information.
If the transmitter is to be placed in storage for a long period of time, remove the batteries and
battery discs from the transmitter and store separately.
As a minimum the bleed screw must be loosened 3 full turns to switch the transmitter off.
A
The Transmitter is shipped with a nylon washer underneath the bleed screw to prevent the unit
being accidentally switched on in transit. This washer must be removed before the transmitter
can be turned on.
