Onkyo TX-SV353, Instruction Manual

Page: 8 / 28

8
Connecting speakers
●
Please connect each speaker according to the illustration, observing the correct connections for R, L, + and –.
●
Do not use unnecessarily long or extremely thin speaker cables. If the DC resistance of the speaker cables is too high, the damping
factor will decrease, adversely affecting the sound quality.
Speaker Impedance
This unit is designed to produce optimum sound quality when speakers with impedances within the set ranges are connected. Please check
the following information and choose speakers with the necessary impedances for the connections.
FRONT SPEAKERS:
A or B : 6 ohms min./speaker
A + B : 12 ohms min./speaker
CENTER SPEAKER: 6 ohms min.
REAR (SURROUND) SPEAKERS: 6 ohms min./speaker
1. Open the lever.
2. Twist wire ends very tight, and insert the
wire.
3. Close the lever.
Before making any connections, please refer
to the explanation of “Speaker impedance.”
Connecting speaker cables
1
2 3
15 mm
Front and Rear speakers
VIDEO-1
VIDEO-1
INPUT
INPUT
VIDEO-2
VIDEO-2
INPUT
INPUT
OUTPUT
OUTPUT
MONITOR
OUTPUT
V V
SUB-
WOOFER
PRE OUT
AVIS
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
FRONT SPEAKERS
L
L
R
R
REAR SPEAKERS CENTER
SPEAKER L R
A
B
A
B
● When using only one speaker or when you wish to listen to
monaural (mono), the single speaker should never be connected in
parallel to both the right and left channel terminals at once.
B terminals
Use these terminals to
connect a second pair
of front speakers.
+ – – + + – – +
R L R L
Rear (surround) Rear (surround)
Front Left Front Right
Left Speaker Right Speaker
Speaker Speaker
Center speaker and subwoofer
PHONO CD TV/AUX TAPE
GND
R
L
R
L
ANTENNA
FM
75
Ω
AM
(PLAY)
INPUT
(REC)
OUTPUT
VIDEO-1
VIDEO-1
INPUT
INPUT
VIDEO-2
VIDEO-2
INPUT
INPUT OUTPUT
OUTPUT
MONITOR
OUTPUT
V V
SUB-
WOOFER
PRE OUT
WARNING
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
FRONT SPEAKERS
L
L
R
R
REAR SPEAKERS CENTER
SPEAKER L R
A
B
A
B
The SUBWOOFER PRE OUT jack can be connected to a
subwoofer amplifier, or to a subwoofer with a built-in amplifier.
●
When using any unit connected to the SUBWOOFER PRE
OUT jack, set the SPEAKERS A button on the front panel
to ON.
Active Subwoofer
Center Speaker
Amplifier
Subwoofer
Note:
To prevent damage to circuitry, never short-
circuit the positive (+) and negative (–)
speaker wires.
NO