5
Rear Panel
1. DIGITAL IN OPTICAL/COAXIAL jacks: Input TV or AV component digital audio signals
with a digital optical cable or digital coaxial cable.
2. ETHERNET port: Connect to the network with an Ethernet cable.
3. USB port: A USB storage device is connected so that music files stored in it can be
played. You can also supply power (5V/1A) to USB devices with a USB cable.
4. Wireless antenna: Used for Wi-Fi connection or when using a BLUETOOTH enabled
device. Adjust their angles according to the connection status.
5. VIDEO IN jacks: Input the AV component video signals with an analog video cable.
6. HDMI OUT jacks: Transmit video signals and audio signals with a HDMI cable connected
to a TV.
7. HDMI IN jacks: Transmit video signals and audio signals with a HDMI cable connected to
an AV component.
8. Power cord
9. GND terminal: The ground wire of the turntable is connected.
10.AUDIO IN jacks: Input AV component audio signals with an analog audio cable.
11. TUNER AM/FM 75Ω terminal: The supplied antennas are connected.
12.ZONE 2 LINE OUT jack: Output audio signals with an analog audio cable to a pre-main
amplifier in a separate room (ZONE 2).
13.SUBWOOFER PRE OUT jack: Connect a powered subwoofer with a subwoofer cable.
Up to two powered subwoofers can be connected. The same signal is output from each of
the SUBWOOFER PRE OUT jacks.
14.SPEAKERS terminals: Connect speakers with speaker cables. You can connect the
multichannel speakers for the main room and the speakers for a separate room (ZONE
2).
> Before Start
> Part Names
> Install
> Initial Setup
> Playback
180°
90°
SN29402761_TX-NR575E_BAS_En_1701XX.book 5 ページ ２０１７年１月１０日 火曜日 午後７時１４分
