15
Connecting with Bi-Amping Speakers (Page 12)
0
Refer to "Standard Connections (Pages 8 to 11)" (P14) to
connect the center speaker, surround speakers, and
powered subwoofer.
Make sure you remove the jumper bar fitted between the woofer
jacks and tweeter jacks of the front speakers. Make correct
connection between the unit's jacks and speaker's jacks (+ to +
and – to –) for each channel. If connection is wrong, reverse
phase may make bass output poor. Also refer to the instruction
manual for your speakers when using connections for bi-amping.
Make sure the exposed wires of the speakers
do not stick out of the speaker terminals when
connecting. If the exposed wires of the
speakers touch the rear panel or the + and –
wires touch each other, the protection circuit
will be activated.
> Before Start
> Part Names
> Install
> Initial Setup
> Playback
a
1/2˝
(12 mm)
For high-
frequency
For low-
frequency
a
Speaker cable
Setup
0
Settings for the speaker configuration you have
connected need to be made in "1. AccuEQ Room
Calibration" in Initial Setup (P22).
0
If any of the connected speakers have an impedance
of 4 Ω or more to less than 6 Ω, after completing
Initial Setup, you need to make some settings in the
Setup menu. Press
on the remote controller,
select "2. Speaker" - "Configuration" and set
"Speaker Impedance" to "4ohms".
SN29402761_TX-NR575E_BAS_En_1701XX.book 15 ページ ２０１７年１月１０日 火曜日 午後７時１４分
