14
Step2: Connect the Speakers
Standard Connections (Pages 8 to 11)
Make correct connection between the unit's jacks and
speaker's jacks (+ to + and – to –) for each channel. If
connection is wrong, reverse phase may make bass output
poor. Up to two powered subwoofers can be connected.
The same signal is output from each of the SUBWOOFER
PRE OUT jacks.
Make sure the exposed wires of the speakers
do not stick out of the speaker terminals when
connecting. If the exposed wires of the
speakers touch the rear panel or the + and –
wires touch each other, the protection circuit
will be activated.
> Before Start
> Part Names
> Install
> Initial Setup
> Playback
a
b
1/2˝
(12 mm)
a
Speaker cable,
b
Subwoofer cable
Setup
0
Settings for the speaker configuration you have
connected need to be made in "1. AccuEQ Room
Calibration" in Initial Setup (P22).
0
If any of the connected speakers have an
impedance of 4 Ω or more to less than 6 Ω, after
completing Initial Setup, you need to make some
settings in the Setup menu. Press
on the
remote controller, select "2. Speaker" -
"Configuration" and set "Speaker Impedance" to
"4ohms".
SN29402761_TX-NR575E_BAS_En_1701XX.book 14 ページ ２０１７年１月１０日 火曜日 午後７時１４分
