Various settings
31
It
De
∫
3. Hardware
Speaker Impedance:
If any of the connected speakers
have 4
h
or more to less than 6
h
impedance, or if you
have connected a different set of left and right speakers
to the SPEAKERS A/B terminals, set the impedance to
4
h
.
0
Reduce the volume to minimum before setting.
6
h
(default setting)
4
h
Auto Standby
:
The unit will automatically enter standby
mode if there is no operation for 20 minutes with no audio
signal input.
On
(default setting)
Off
Network Standby:
you can turn on the power of the unit
via network using an application such as Onkyo Remote.
On
Off
(default setting)
0
When “Network Standby” is used, the power
consumption increases even when the unit is on
standby. However, the increase in power consumption
is kept to a minimum by automatically entering the
HYBRID STANDBY mode, where only the essential
circuit is operating.
0
If it is not displayed, wait for a moment until the
network feature starts.
Opt1 In Wakeup:
When an audio signal is input through
the OPTICAL terminal while this unit is in standby, this
feature automatically detects it.
Off
(default setting)
On
: This unit is turned on and outputs the audio.
0
When a cable is connected to the OPTICAL terminal
and this setting is enabled, power consumption
increases even when the unit is on standby, however,
the increase in power consumption is kept to a
minimum by automatically entering the HYBRID
STANDBY mode, where only essential circuits are
operating.
AM Freq Step:
Changes the AM radio frequency step.
9kHz
(default setting): The frequency is adjusted in
increments of 9 kHz.
10kHz
: The frequency is adjusted in increments of
10 kHz.
∫
4. Source
IntelliVolume:
Even when the volume control is the same
on this unit, there may be differences in the volume
depending on the connected devices. Adjust this when
you want to alleviate this difference. To set, select each
input source.
j
12 dB
to
i
12 dB
(default setting: 0 dB)
Name Edit:
Enter a simple name of up to 10 characters
in length for the input sources or preset AM/FM stations.
To set, select each input source or select the preset
number of the registered station.
0
For information on how to input characters, see
“Inputting characters” (
>
30).
∫
5. Network
Make the network setting.
0
If it is not displayed, wait for a moment until the
network feature starts.
0
When LAN is configured with a DHCP, set “DHCP” to
“Enable” to configure the setting automatically.
(“Enable” is set by default) To assign fixed IP
addresses to each components, you must set “DHCP”
to “Disable” and assign an address to this unit in “IP
Address” as well as set information related to your
LAN, such as Subnet Mask and Gateway.
MAC Address:
View this unit’s MAC address.
DHCP:
Enable
(default setting)
Disable
IP Address:
View/set the IP address.
Subnet Mask:
View/set the subnet mask.
Gateway:
View/set the default gateway.
DNS Server:
View/set the DNS server address.
Proxy URL:
Set the proxy server address.
Proxy Port:
Set the proxy port number.
0
This only appears when Proxy URL has been set.
Friendly Name:
Change the name for this unit to a
simple one for display on the equipment connected by
network. Press the ENTER button and input 31 or less
characters.
0
For information on how to input characters, see
“Inputting characters” (
>
30).
Network Check:
You can check the network connection.
Press the ENTER button when “Start” is displayed.
TX-8130_mst.book 31 ページ 2015年11月2日 月曜日 午後1時16分