MD-101A
T E M P A D J U S T
T E M P = & &
T E M P A D J U S T
T E M P = & & S AV E
1
FL Display
ADJUSTMENT PROCEDURES-4
The adjustment method
Adjustment of temperature compensation value
[NONE]
(1) Perform circumference temperature in the 22 to 28 degrees state.
(2) Adjust, after exchanging D101, and the temperature of this part turns into the
same temperature as circumference temperature.
[Adjustment]
(1) Select the
TEMP ADJUST
in the test mode.
(2) Press the
JOG
knob.
(3) Press the
JOG
knob.
[CONNECTION]
(1) Connect to extended jig and the unit.
(2) Short-circuit WP terminal on the extended jJIG and the chassis ground. (Refer to setting WP)
