![background image](http://html.mh-extra.com/html/onkyo/c-1045/c-1045_instruction-manual_1638008023.webp)
23
First Time Setup
Setting the Clock with the AccuClock Function
RDS is only for the area where RDS broadcasts are available.
To use the AccuClock function, the stereo receiver must be able to receive RDS radio stations, which means an FM
antenna must be connected. Be sure to connect an FM antenna before attempting to use this function (see pages 17 to 18).
The very first time you turn on the stereo receiver, the AccuClock function automatically sets the stereo receiver’s clock
based on the CT (Clock Time) information present in an RDS radio broadcast. While the clock is being set, “Wait…”
flashes on the display, as shown. Note that it may take up to 5 minutes to set the clock.
When the clock has been set, the message “Clock Adjusted” scrolls across the display, then the day and time are
displayed for a while, as shown.
The AccuClock function automatically updates the clock daily at 02:00, 03:00, and 14:00.
If for some reason the clock cannot be set automatically, see “Setting AccuClock to Using a Specific Station” on page 55
and “Setting the Clock Manually” on page 56.
Notes
To cancel this function while “Wait…” is displayed, use the [INPUT] knob, press [MODE/RETURN] button, or MULTI
JOG controller.
Turning Off the AccuClock Function
If you don’t want AccuClock to automatically update the clock each day, you can turn it off as follows.
Notes
The AccuClock function cannot be turned off until the
clock has been set.
TIMER
MODE/YES
1
Press the [TIMER] button repeatedly
until “Clock” appears on the display.
2
Press [
].
“AccuClock” appears on the display.
3
Press the [MODE/YES] button.