![background image](http://html.mh-extra.com/html/onkyo/c-1045/c-1045_instruction-manual_1638008062.webp)
62
Troubleshooting
How to reset to factory default?
R-1045/R-1045DAB
If you have any trouble using the stereo receiver, look for a solution in this section.
C-1045
If you have any trouble using the CD Player, look for a solution in this section.
Power
Can't turn on the stereo receiver.
• Make sure that the power cord is properly plugged into the wall outlet (see page 22).
• Unplug the power cord from the wall outlet, wait 5 seconds or more, then plug it in again.
Can’t turn on the CD Player.
• Make sure that the power cord is properly plugged into the wall outlet (page 22).
• Unplug the power cord from the wall outlet, wait 5 seconds or more, then plug it in again.
The stereo receiver turns off unexpectedly.
• If the sleep timer has been set and the TIMER indicator is shown on the display, the stereo receiver will turn off
automatically after a specified period.
• When timed playback finishes, the stereo receiver automatically switches to Standby mode.
• If the STANDBY LED is flashing, the built-in amplifier protection circuit has been activated. This can happen if
there’s a short between the positive and negative wires of a speaker cable.
Audio
There's no sound.
• Make sure the stereo receiver’s volume control is not set to minimum (see page 25).
• Make sure the correct input source is selected (see page 25).
• The audio input signal selected by the input selector is output to LINE2 OUT.
However, no audio signal is output if LINE2 is selected by the input selector.
• Make sure the stereo receiver is not muted (see page 26).
• Make sure the speakers are connected correctly (see page 19).
• Check all connections and correct as necessary (see pages 16 to 22).
• While headphones are connected, the speakers output no sound (see page 26).
• The speakers output no sound when it is connected with the iPod.
• Make sure that there is no unsupported file formats or signals.
1 While holding down the [MODE/RETURN] button, press the [ON/STANDBY] button on the
main unit.
2 “Clear” appears for 3 seconds on the display, then the stereo receiver will automatically go
Standby.
Do not operate the stereo receiver while “Clear” is displayed.
Note that resetting the stereo receiver will delete your custom settings.
If you can’t resolve the issue yourself, try resetting the CD Player before contacting your Onkyo dealer.
To reset the CD Player to its factory defaults, turn it on and, while holding down the [
]
button, press the [ ] button. “Clear” will appear on the display.
Note that resetting the CD Player will delete your custom settings.