Page 10 of 16
Rev 1
5.1 Auto Off
This controller is fitted with a 3 hour Count Down Auto Off Timer which starts to
countdown from when your heat setting has been selected, and will switch power
off to the elements after approximately 3 hours. (+/- 15 Minutes)
Note
: Once a heat setting has been selected and the controller is powered ON, the
countdown timer will not be affected by adjusting heat level.
The timer will only be reset to 3 hours by sliding the control knob to heat level
“O” or after being powered OFF and then back On.
When the controller has timed out, the element will turn off and the Red LED’s
will flash.
Slide the control knob to the “O” position to reset.
TURN OFF AND UNPLUG THE HEATED THROW WHEN NOT IN USE
.
5.2 Pre Heat
The controller has a pre-heat facility in order to warm the Heated Throw Quickly.
Once you are warm enough, please turn the controller down to setting 2 or 3.
Please
DO NOT
leave the Heated Throw set on the Preheat setting (No. 3) once
you are warm enough as you may get too hot.
NOTE: The Heated Throw may not feel warm to touch unless it is wrapped
around your body. Areas of the Throw not in contact will stay cool.
6 Using Your Heated Throw
•
Read the Important Safeguards section first, then ensuring the Heated Throw is
fully unfolded, not creased and the controller plug is fitted securely, you can then
plug in and switch on.
•
Wrap the Heated Throw around your body or drape over your legs.
The Heated Throw
MUST NOT be used as an Under Blanket
(as per with an
ordinary Electric Blanket) instead the Heated Throw must only be used by
Wrapping around your body and shoulders or draping over your legs etc.
When Wrapping the Throw around your body and shoulders, ensure the
controller connection is at the bottom and facing on the outside for comfort.
If using in conjunction with another normal blanket, place the Heated Throw on
top of the other blanket. The Heated Throw must always be positioned on the
outside to prevent overheating.
•
Do Not fold, roll, kink or trap the cables. Allow the cables to hang freely. Ensure
the cables are not pulled so tight that it bends hard at the Heated Throw
connector end.
Summary of Contents for T624W100DA2b
Page 2: ...Page 2 of 16 Rev 1 ...
Page 4: ...Page 4 of 16 Rev 1 ...
Page 16: ...Page 16 of 16 Rev 1 ...