Silencer
4. Clamp Cartridge Filters to the Plenum. Clamp
the Dust Bins to the bottom of the Filter Cartridges.
See Ill. 5.
(L-Clamps are packed separately with
hardware.)
VI. Assembly Instructions
(Cont.)
5. Attach flex hose to bottom of collector and to lid of dust
bin. Securely fasten hose clamps. There must be an air
tight seal between the collector and dust bin.
6. Make sure the dust bin lid sits securely and the rubber
gasket on the bin lid is in place on the barrel. Maintain an
air tight seal between cyclone and dust bin to prevent motor
from overloading.
IMPORTANT:
Do not operate the collector until the dust bin is in place and
the connector is air tight or motor damage could result!
Stay clear of fan exhaust while collector is operating.
Collector
Hose Clamp
Hose Clamp
Flex Hose
Dust Bin
6.
7. Attach the ductwork from the woodworking machines to the inlet of the collector.
8. On external filter models, attach the Plenum Assembly or connect to your own plenum box.
9. Attach feet of Angle Iron Stand to floor.
Note: Assembly with Tube Filters - Note plenum height requirements of Tube Filters - 6 tubes - 8 plenum / 8 tubes -
10 plenum / 10 tubes - 12 plenum. Adjust system height accordingly.
O.A.S. 2008
c
5 - 7.5 HP Direct Drive Owners Manual
8
5.
Hook Lever
Clamps to
bottom of filter
130 Sq. Ft.
Filter
Hold Filters on
plenum assembly
level then tighten
nut against
(4) L-Clamps.
L - Clamps
Pat. Pending
11/413,728
Silencer easily drops
into Filter. Hold filter
up to Flange Plate
and clamp.
