8
V - Systems Owner’s Manual © O.A.S. 2010
7. Line up the holes in housing with the holes in the motor
plate. Then attach using provided 5/16” flange bolts and
5/16” washers. You will need a sturdy step ladder for this.
8.Place gasket material around filter plate as shown in dia
-
grams. You may have to partially cover the bolt holes. Just
make sure that there is enough room for the bolts to push
through. and that there is no gap where the ends meet.
10. Attach gasket to
housing outlet, making
sure there is no gap
where ends meet. You
may have to trim out
some gasket to ensure
that the bolt holes are
clear.
11 The (7) 3/8” hex head
bolts and whiz nuts to
attach the plenum are in
the kit hardware.
4 hole side is near dust collector.
Gasket
Filter
Mounting
Plate
Gasket
Plenum
Support
Hanger
J Hook
J Hook
Gasket
Outlet
9. Attach Plenum to Plate:
Push Carriage bolts through
bottom of filter plate making
sure gasket side is up and
rectangular shaft is in hole.
Tighten with 5/16” whiz nut
and washer as shown in dia-
gram. Make sure plate is at-
tached to the support hanger
end of plenum as shown in
diagram to the right.
Filter
Plate
Washer
Nut
Bolt
Plenum
