9
V - Systems Owner’s Manual © O.A.S. 2010
18. Plug in Magnetic Starter and you are ready to connect
your collector to your ductwork and go!
16. Distance between the drum lid and cone can vary.
Some systems have little space there to minimize overall
system height.
In some cases, the flexible hose will have to be cut down
(especially with stands).
OAS ships 1’ of hose as standard but this is not necessarily
the needed length once the system is installed.
Tools Needed: Razor Knife / Diagonal Cutters
Measure length between drum lid and collar of cone.
Measure hose while it is extended (don’t overly compress
the hose). This allows the lid to move up when installed.
Cut the hose with razor knife and then cut the wire with
diagonal cutters.
Don’t cut too short! If in doubt, cut a
little long.
Trim if necessary.
12. Pull Silencer out straight
and place in top of filter,
pushing it down into filter until
top ring is flush with filter and
fits snugly within the gasket.
13, Put 4 J-hooks into filter plate as shown above and
loosely tighten with thumb nuts.
14. Hook J-hooks under metal rim of filter and evenly
tighten, making sure filter’s gasket is tightly sealed against
filter plate.
15. Put J-hooks through Dust Bin as shown and tighten
with Thumb Nuts, making sure you have an even seal
between the filter gasket and Dust Bin.
17. Connect short end of Filter Grounding Wire from motor
to plenum bolt as shown below and clamp alligator clip to
filter mesh.
Filter
J-Hook
Dust Bin
Thumb Nut
Ring Terminal
End
Filter
Plate
Filter
Washer
Nut
Bolt
Plenum
Collector
Hose Clamp
Hose Clamp
Flex Hose
Dust Bin
Drum Grounding Wire
To attach the Drum
Grounding Wire, start a
small hole in bottom of
cone above flex hose
and in the top of the
dust drum, then attach
the wire with the 3/8”
included self-tapping
screws.
