18 Oneida Air Systems
Industrial Assembly Instructions
Pull Tether
Strap tight
Loop this
end around
Hose.
Thread Tether Strap through
Ladder Lock Slider.
FIG. 16
FIG. 17
FIG. 18a
FIG. 18b
16
Install Dust Sentry sensor (M) onto your
Drum Lid (E) per included instructions:
Dust Sentry Instructions
#ZBI000002A
Mount the Dust Sentry strobe light (M)
centered between the two holes of the Strut
(F7) using the hook and loop tape (F22 and
F23). Secure onto the Strut (F7) through the
two holes with a Phillips Drive Pan Head
Screw (F19), Washer (F20), and Nylock
Nut (F21). Plug in the Dust Sentry (M) to
the connecting adapter found on the Motor
Assembly (A) [FIG. 16].
Note: You may mount the Dust Sentry (M) in
an alternate location that works best for your
setup.
17
Install Tether Strap Plate (K4) with Hex Head
Bolt (K2) and Square Nut (K3) in the front of
the Molded Drum Dolly (L) [FIG. 17].
18
Use one of the Ladder Lock Sliders (K5) to
secure one end of the Tether Strap (K1) to
the Tether Strap Plate (K5). See [FIG. 18a]
on instructions how to thread the ladder lock
slider. Loop the other end of the Tether Strap
(K1) around the center of the inlet Hose (O).
Use the second Ladder Lock Slider (K5) to
secure the Tether Strap (K1) to the inlet Hose
(O). [FIG 18b]
If you did not purchase the Vortex Unit
(#VOR), your installation is complete!
K2
K3
K4
F20
F19
F23
F22
F21
