16 Oneida Air Systems
Assembly Instructions (Continued)
FIG. 13
FIG. 12a
Retaining
Stud
Retaining
Stud
FIG. 12b
FIG. 11
THE FAN BLOWER ASSEMBLY IS HEAVY AND CUMBERSOME. BE SURE TO HAVE ADEQUATE
HELP WHEN LIFTING!
11
Carefully install the GORE® CleanStream Pro
HEPA Filter (C) onto the ring and then slip
filter retainer strap (F18) to secure. [FIG 11]
Note: It is VERY important that the strap be
tight enough to hold the filter snugly in place
yet not so tight as to pull down and damage the
filter. Be careful not to crush the flame arrestor
mesh.
12
Align the two retaining studs on the bottom of
the Motor Assembly (A) with the two notches
on the Cone Assembly (B) [FIG 12a] and
fasten these components together with Draw
Latches (F24) on either side. [FIG 12b.]
Note: Clean, HEPA filtered air will exit from the
Motor Assembly during operation to aid with
heat dissipation.
13
Insert a Drum Liner Bag (F41) into the Drum
(D), making sure it fully expands against the
sides and the bottom of the Drum. The top
edges of the bag should fold out and over the
Drum’s upper rim [FIG. 13].