CARVER USER’S MANUAL
16
04
U
se
and
C
onfigUration
of
the
e
qUipment
d
) r
eSet
. 4
LedS
b
Linking
3. Once the controller has reached all 4 LEDs, all
the information will be stored and all LEDs turn off.
If you do not want to change any of these parameters you don’t need
to do this process again, it will remain in the internal memory of the
controller.
4. To check the current status you can repeat the step 1 but press on the
drop only one time instead of holding it pressed. The controller will show
the preferences for each category.
5. Always use the controller inside the controller wristband.
6. Always secure the wirstband before use.
7.
In order to activate the jet, press on the drop with the index finger and
thumb.
8. The power will vary depending on the pressure placed on the drop.
4.2.2 . c
harging
the
controLLer
1.
Connect the Qi charger through a USB.
2. Place the controller on the center of the Qi as shown in the drawing
below.
3. When charging, the green LED will begin to blink.
4.
Once the controller is fully charged, the LED will turn off.
5. To check the status of the battery of the controller please pick it up and
press on the drop to see the battery LED-.
SYNC
BATTER
Y
