CARVER USER’S MANUAL
13
04
u
Se
and
c
onFiguration
oF
the
e
quiPMent
b
) d
iSconnection
Avoid pulling from the cable, always pull
from the connector body.
c
) i
MPortant
Always supervise the charge, do not leave
the batteries unnatended while charging.
• The batteries does not need to be fully discharged before charging.
A
Lithium Ion battery doesn´t have memory effect
. This means that the
maximum energy capacity won´t be affected if its charged after not being
fully discharged.
• Make sure that the batteries do not remain to be connected to the
charger after the charge has been completed
.
• Always remember to
close the battery rubber
connector covers before
use.
• The temperature use for the batteries must always remain between 0ºC
and 60ºC (32ºF y 140ºF).
•
Extreme temperatures will affect the batteries life
, specially during
charge. Avoid charging the batteries while being exposed to direct sunlight
or extreme high or low temperatures. The charge is recommended to be
carried out with temperatures (between 10ºC y 45ºC / between 50ºF y
113ºF).
•
Do not overdischarge the batteries.
Do not continue riding once the
power starts to decrease and the LEDs on the top bar begin to blink, this
has been proven to decrease the battery’s capacity over time. This is an
extra energy resource which must be used only for emergencies.
4.2. w
ireLeSS
c
ontroLLer
To activate the board you must press on the drop. The power of the Jet will
depend on the amount of pressure done on the drop.
4.2.1. c
ontroLLer
c
onFiguration
Through the wireless controller you can set the maximum power for the Jet
and also adjust different profiles.
In order to access the configuration menu, you must follow the following
indications. Always with the batteries initially disconnected:
1. With the controller totally off (no LEDs ) place
the drop over the logo.
2. On this position, press on the drop
until the first LED of the board display
SYNC
BATTERY
Drop
Sync
Controller
battery
Board Battery
Power
Indicators
SYNC
BATTERY
1
Connector
body
Cable
