CARVER USER’S MANUAL
10
04
U
se
and
C
onfigUration
of
the
e
qUipment
4.1. b
atterieS
4.1.1. t
ranSPort
and
Storage
oF
batterieS
• In order to travel with the board, the batteries must be below 20% of charge.
This means that the LED bar must be only showing one LED.
Placing the drop near the battery display you will be able to check the
battery level.
• Do not transport the batteries inside the board unless you intend to
use it inmediately.
Always use the side handle to transport the battery
pack. Do not pick it up by the top handle.
• Between uses you should store the batteries between 0ºC and 40ºC (32°F
and 104°F) always less than 3 months, in a ventilated area and with a
humidity between 0% - 80%. Do not store the batteries near metallic
objects.
4.1.2. c
onnecting
/d
iSconnecting
the
batterieS
Always charge the batteries and remote to the fullest before operating the
equipment.
Connection and disconnection of the battery:
1. Check the watertight seal and the battery housing to make sure they are
clean and free of sand. Make sure there aren´t any signs of damage before
use. Make sure there isn´t any water inside the battery compartment.
2. Turn the vent one full round counter-clock wise. Place the battery on the
pad, near the battery compartment where
the battery must be placed. Once the battery
is placed on the pad, grab it by the upper
handle and place in the battery compartment.
The blue LED on the front of the board
will light up indicating the connection.
Drop
Sensor
Charging
indicator
Battery connectors
SYNC
BATTERY
Display
Battery percentage
20%
40%
60%
80%
100%
