Page 12
For technical questions, please call 1-800-444-3353.
SKU 68825
Replacing The Scraper
1.
Figure 18
Scraper
Screws
The Scraper is located at the base of the
Snow Thrower beneath the rotor housing.
2.
Figure 19
Detach the worn Scraper from the Snow
Thrower by removing the 3 Screws that hold
it in place, then pull it from the unit.
3.
Figure 20
Install the new Scraper (153) and fasten it
securely to the Snow Thrower with 3 Screws.
Replacing The Belt
Note:
Determine the left and right hand sides
of the Snow Thrower by standing behind the
unit in the normal operating position.
1. Remove the 4 Screws from the Left Cover of the
Snow Thrower.
2.
Figure 21
Lift the tensioner Pulley and roll the
Belt off the Large Pulley.
3. Replace with a new Belt (123), then
secure the Left Cover of the Snow Thrower
back in place with the 4 Screws.
Storing The Snow Thrower
1. Allow the engine to cool and clean the Snow
Thrower before storing or transporting. Be
sure to secure the unit while transporting.
2. Disconnect the extension cord from the Snow Thrower.
3. Inspect the extension cord closely for signs of wear
or damage. Replace it if it is worn or damaged.
4. Inspect the Snow Thrower carefully for worn,
loose, or damaged parts. Check connections
and screws and tighten if necessary.
5. Store the unit, along with the disconnected extension
cord, in a locked, dry place out of the reach of children.
Cover loosely with a tarp for added protection
.
