9051_Bedienungsanleitung_C1_Rev2_EN_UK – Stand 08.08.2018 TS / MB
19
6.3.6 Factory reset (menu F3)
If you wish to reset the controller to the factory settings because you do not wish to retain the changed settings,
or notice an error, or were asked by a Service employee from Oelschläger
Metalltechnik
GmbH to do so,
proceed as follows:
1. Press the “Logo” key for 5 seconds.
2. With the “Up” and “Down” keys, select the menu option
.
3. Confirm the selection by once again pressing the “Logo” key.
4. The following is shown in the display
5. Press the “Logo” key once again so that all the settings are reset to the factory settings.
The program now quits the main menu and displays
. To complete the operation, carry out a reference
movement.
6.3.7 Shelf- or Container Stop
The end positions of the table can be matched to the ambient conditions. The upper end position (shelf-stop)
can be defined by an incline of the roof or a ceiling light and the lower end position by a mobile file cabinet
(container stop).
6.3.7.1 Setting (menu F4)
To set a shelf- or container-stop, follow the procedure below:
1. Use the arrow keys to move to the desired position.
2. Press the “Logo” key for 5 seconds.
3. With the keys “Up” and “Down”, select the menu option
.
4. There appears a display with one bar each at the top left and bottom right.
5. To save the upper limit position, select the “Arrow up” key.
6. To save the lower limit position, select the “Arrow down” key.
7. Confirm the input with the “Logo” key.
To quit the menu without making a selection, wait for about 10 seconds till the height display appears again.
6.3.7.2 Delete (menu F5)
To delete a shelf-stop or a container-stop, proceed as follows:
1. Press the “Logo” key for 5 seconds.
2. With the keys “Up” and “Down”, select the menu option
.
3. There appears a display with one bar each at the top and bottom.
4. To delete the upper limit position, select the “Arrow up” key.
5. To delete the lower limit position, select the “Arrow down” key.
6. Confirm the input with the “Logo” key.
To quit the menu without making a selection, wait for about 10 seconds till the height display appears again.
