9051_Bedienungsanleitung_C1_Rev2_EN_UK – Stand 08.08.2018 TS / MB
12
4.4 Assembly of the controller and hand-switch
First fit the two controller brackets into the keyholes in the longitudinal spar. Then turn them clockwise through
90 degrees.
Note:
Ensure that the grooves for the cable guidance are on one side, so that the cables can be
later laid skirting by the STAND.CONTROL C1.
Now position the locking catches of the brackets on the two holes on the rear side of the motor controller and
click the brackets into place with moderate pressure on both the components on the controller.
Now fit the hand switch on the table top. There are holes of ø 5.2 mm provided on the hand switch. The
tightening torque depends on the material of the table-top but must not exceed 2 Nm.
*1)
Moreover, the STAND.CONTROL C1 is equipped with threaded holes of ø 6.3 mm and can be optionally
screwed to the table-top. The tightening torque depends on the material of the table-top but must not exceed 2
Nm.
*1)
*1)
The screws are not included in the scope of delivery since they have to be selected depending on the
material and the thickness of the desktop.
90°
