4-19
ZUV
User’s Manual
Section 4
CONNECTING TO EXTERNAL DEVICES
Section 4
Connection by USB/RS-232C
DATASAVE command
This command saves the setting data to the flash memory in the controller.
All settings will be deleted if you turn the power OFF without saving the data.
Setting data can also be saved by menu operations without using commands.
Turn the key switch on the controller front, and change the LOCK mode to the READY mode. The
save confirmation message is displayed. The save confirmation message is displayed only when
the settings have been changed. Otherwise, it is not displayed.
(1)
Parameter description
No parameters are provided for the DATASAVE command.
(2)
Command/response examples
The following shows an example of this command:
The following shows an example of a response to this command:
DATASAVE
OK
DATASAVE
←
Setting data in flash memory is saved.
OK
←
Command execution ends successfully.
Command
Delimiter
Delimiter
Response
Delimiter
Delimiter
Delimiter
Delimiter
Delimiter
Delimiter
Summary of Contents for ZUV Series
