![background image](http://html1.mh-extra.com/html/omron/viper-650-eplc/viper-650-eplc_quick-setup-manual_743999010.webp)
1.6 Configuration
Installing ACE Software
ACE is used to change the IP address of the robot and for troubleshooting. You install the ACE
software onto your PC from the ACE disk.
NOTE
: You will have to restart the PC after installing ACE software.
Setting the Robot IP Address
Configure the IP address of the Viper ePLC robot using ACE software.
1. Connect the PC and the robot, either through a shared network or with an Ethernet
cable between them.
2. Start the ACE software.
3. Click the Detect and Configure button, circled in the following figure.
Figure 1-6. Detect and Configure Button
The IP address detection and configuration window will open. The ACE software will show
the IP address of any controllers it detects. See the following figure.
Viper ePLC650/850 Quick Setup Guide, 13589-000 Rev D
Page 10 of 14
Summary of Contents for Viper 650 ePLC
Page 1: ...I600 E 01 Viper 650 850 ePLC Quick Setup Guide...
Page 13: ......