47
Setting Editing Screens
Section 4-2
4-2
Setting Editing Screens
Use the following procedures to display the screen shown below.
To create a new project:
• Select File(F)/New; or
• Press the Ctrl+N Keys; or
• Select the New Project Icon from the toolbar.
To select an existing project:
• Select File(F)/Open; or
• Press the Ctrl+O Keys; or
• Select the Open Icon from the toolbar.
Note Refer to SECTION 5 Saving and Reading Projects for information on opening
an existing project
Example: The following screen will be displayed after creating a new project
4-2-1
Displaying Setting Editing Screens
Use the following procedures to display individual Setting Editing Screens in
project window.
To Display Individual
Setting Editing
Screens
With the project tree displayed, select the settings to be displayed for the
specified NC, and either double-click or press the Enter Key.
X- and Y-axis editing screens will be displayed for 2-axis NC Units; X-, Y-, Z-
and U-axis editing screens will be displayed for 4-axis NC Units
To Display the Parameter
Editing Screen
1,2,3...
1.
Under the NC on the project tree, either double-click Edit NC Parameters,
or select it and press the Enter Key.
Summary of Contents for SYSMAC W398-E1-1
