3-4
Operation by External Terminal Signals
RESET
FREQUENCY REFERENCE
DISPLAY
DSPL
DATA
ENTER
OUTPUT FREQUENCY DISPLAY
PRGM
DRIVE
RESET
DATA
ENTER
PRGM
DRIVE
DSPL
POWER SUPPLY ON
Select PRGM mode by
key.
Operator
Display
SET VALUE WRITE-IN
OPERATION CHECK
RUN
STOP
(Increased to 60 Hz)
(Decreased to 0.0 Hz)
PRGM MODE SELECTION
OPERATION CONDITIONS SET
DRIVE MODE SELECTION
FREQUENCY SET
(DRIVE display is turned off.)
is selected by
key.
Select a digit by
key and set
by
or
key.
Depress
key to display data.
Select a digit by
key and set the data to 0000
by
or
key.
Depress
key to check for END display.
(Operation by external terminal signals enabled.)
Change to the DRIVE mode by
key.
Check for frequency reference value of external terminals
13 or 14.
Change to output frequency display by
key.
Closed/open between terminals 7 to 11 to perform
inching operation.
After checking for normal operation, close between external
terminals 1 and 11 to perform FWD run.
Open between external terminals 1 to 11 to stop.
!" %&
Section 3-4
Summary of Contents for SYSDRIVE 3G3IV
