No.13S062-07
9/53
STC-MBE132U3V / MCE132U3V / STC-MCE132U3V-C
Product Specifications and User’s Guide
Model Number
STC-MBE132U3V
STC-MCE132U3V / STC-MCE132U3V-C
Operational Mode (*4)
Edge preset Trigger / Pulse width Trigger / Start Stop Trigger /
Free run
User Setting Storage
Support
Communication
Through USB3.0 bus
Interface
USB3.0 Super speed (USB3.0 micro B)
Protocol
USB3 Vision® 1.0.1, GenICam Standard Version (SFNC 2.0, PFNC 2.0) compliant
and Sentech’s original protocol (on Standard SDK, Trigger SDK)
Input / Output
Two inputs and two outputs
Power
Input Voltage
+5V (typ.) (This conforms to USB standard)
Consumption (*5)
Less than 2.0 W
Default:
Bold
Precautions
(*1) The horizontal and vertical binning setting are changed at same time.
(*2) The horizontal and vertical decimation setting can be change individually.
(*3) The binning and decimation function can be use simultaneously.
(*4) Please do not apply the Trigger through maximum frame rate on Trigger Mode. When Trigger applies
within sensor Readout as exposure end, camera interrupted Readout.
(*5) The camera operates as USB3.0 standard even the camera connecting to a USB 2.0 port. Please careful
about the power consumption of the camera when the camera connecting to USB2.0 port.
The guideline to perform the full frame rate with full resolution of camera
The data transfer speed on the USB bus is depending on the performance of USB host controller.
The data transfer speed on the USB bus is very important to obtain full frame rate with full resolution. (60 fps @
1.3M)
Renesas / Fresco Logic host controller improved the data transfer speed drastically in the second generation.
However, the transferring speed of Intel chipset is 10 to 20% faster than these host controllers.
When using USB3.0 interface PCI Express board, please insert it to the PCI Express Gen2.0 (5.0[GT/s]) slot. If
non-PCI Express Gen2.0 (5.0[GT/s]) is used, data transfer speed could decrease by about 50%.
If the frame rate is slow due to the performance of USB host controller, the frame rate of camera should adjust
based on the performance of USB host controller. This may resolve to increase the frame rate.
PC resources may have consumed during the image processing (color interpolation, image display, etc.) with huge
image data from camera.
