1-10
1-10
1-3
Special Adjustment Parameters
Gains and adjustment parameters for all OMRON Servo Drivers are described below.
The auto-tuning function incorporated by the U Series allows easy automatic gain ad-
justment according to the machine system.
H
Auto-tuning Function (U Series)
·
The auto-tuning function allows automatic gain adjustment according to the load while operating the
machine system.
·
The ideal adjustment according to the rigidity of the machine system will be possible by just selecting
the response characteristics if the auto-tuning function is used. It is thus recommended that this func-
tion be used as much as possible.
·
The auto-tuning function is available to all machine systems except the following, which may require
manual adjustment.
Machine systems with heavy friction
Machine system with low rigidity
H
Semi-auto-tuning Function (H Series)
·
The semi-auto-tuning function makes it possible to adjust the speed loop proportional gain and inte-
gral gain by just setting the load inertia ratio to the rotor inertia ratio of the motor.
·
The most suitable gain according to the inertia ratio is preset as a table.
·
Manual adjustment is required for machine systems with heavy friction or low rigidity.
·
The position loop requires adjustment according to the machine system. The semi-auto-tuning func-
tion does not perform position loop adjustment.
H
AC Gain (R Series)
·
The AC gain is used to adjust the speed loop proportional gain and integral gain simultaneously.
·
The ratio of the proportional gain to integral gain is fixed.
C
om
pe
ns
at
in
g
fo
rc
e
Change in Response Characteristics vs. AC Gain
Frequency (operating speed)
Gain Adjustment
Chapter 1
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : [email protected]