DC Power Supply
The OMRON S8VK-series power supply is recommended for use with the Industrial Monitor.
Additional Information
• Refer to
on page 2 - 13 for more information.
• Refer to
4-1-2 General Electrical Specifications
on page 4 - 3 for power consumption details.
Power Connector Wiring Procedure
Use the following procedure to wire the power connector.
1
Remove the sheath from the power supply wires.
7 mm
Precautions for Safe Use
Observe the following to precautions to prevent broken wires.
• When you remove the sheath, be careful not to damage the conductor.
• Connect the conductor without twisting the wires.
• Do not weld the conductors. Doing so may cause the wires to break with vibration.
2
Insert a screwdriver in the small orange groove above the cable opening
1
. Push the screw-
driver
1
to unlock the cable entry and then push the wire all the way to the back of the cable
opening
2
.
1
2
1
2
Pin
Description
1
24 VDC
2
0 VDC
3
Remove the screwdriver.
Do not apply stress to the cable after you have connected the wires.
5 Installation
5 - 25
NY-series Industrial Monitor User's Manual (W554)
5-3
W
ire
5
5-3-2 Wire the Power Connector
Summary of Contents for NYM12W-C100
