3- working modes
Quick reference NS600
OMRON EUROPE MAC centre
QUICK REFERENCE NS600.DOC
Pag. 11
3- working modes
There are two different modes to operate the board:
-
Program table mode
-
Serial commands mode.
3.1.- Program table mode.
In this mode the NS600 works using the parameters stored in form of tables (program, zones and jog) stored into memory.
To program this table the INDEXWORKS software is needed.
Working in this mode is also possible to select mode 0 or mode 1 by a digital input CN4-3. In mode 1 we can work with
multispeed (up to 16 jog speeds) and also make and origin search (homing). In mode 0 we can select between several
positionings stored into a table.
3.1.1.- MODE 1
3.1.1.1.- Jog speed table operation.
With the programming software INDEXWORK, is possible to program a table with 16 speeds (JSPD0 to JSPD15) and
depending on the status of digital inputs JOG0/JOG1/JOG2/JOG3 is possible to select any of them. Also is possible to
select the rotation direction by the signals JOGP for forward movement or JOGN for reverse operation.
All the jog speeds are stored into the NS600 memory table and the inputs could be programmed in the parameters Pn-805
to Pn-80A. (Only activation level because the pin number is fixed)
NOTE: (It works in the same way that multispeeds in the inverters)