Omron NS - HOST, Connection Manual

Page: 43 / 63

6
3-2-2 Communications conditions setting
In NS-Designer, select tab ‘Comm.-All’ Serial Port A (or Serial Port B) and set to the
following communications conditions.
Parameter Set value Default value
Baud rate 9600bps / 19200bps / 38400bps 9600bps
Data bits 7 / 8 7
Stop bits 1 / 2 1
Parity None / even / odd none
response OFF / ON OFF
Notice start $B 0 to 32767 16384
Notice start $W 0 to 32767 16384
3-2-3 NS system menu operation
You can also use the NS system menu to set the communications conditions for
the Memory Link connection.
Under system menu, click tab
Communications Setting.
By pressing the key beside the Serial Port A or Serial Port B, you can switch between
communications methods.
unused
↓
NT Link 1:1
↓
NT Link 1:N
↓
Bar code reader
↓
Temperature controller
↓
Memory Link
↓
Host Link
↓
Modem
After you have thus set communications to Memory Link, use the Details key to set
the communications conditions for the Memory Link connection (for details, refer to
section 2.2). However, with system menu you cannot set the Notice start $B and
Notice start $W .
Set values are not saved until you press the Write key. Also, setting changes will be
effective when you turn the power OFF and then ON again.