F-14
1/32 DIN Digital Panel Meter
K3GN
Dimensions
Note: All units are in millimeters unless otherwise indicated.
■
Wiring Precautions
• Wire the power supply with the correct polarity. Wiring with incorrect polarity may result in damage or burning.
• Wire the terminals using crimp terminals.
• Tighten terminal screws to a torque of approx. 0.5 N·m.
• Wire signal lines and power lines separately to reduce the influence of noise.
■
Wiring
Power Supply
• Input 24 VDC to terminals 1 and 2.
• Use M3 crimp terminals of the type shown below.
Measurement Input
The following table shows the relation between input ranges and
input terminals.
/ZERO
ZERO
OUT1
OUT2
SV
HOLD
CMW
T
K3GN
3
80
22
44.8
48
24
35
Separate mounting
Gang mounting
22.2
+0.3
0
22.2
+0.3
0
45
+0.6
0
(48
×
No. of Panels
−
2.5)
+1.0
0
40 min.
The products cannot be
made waterproof when
gang-mounted.
7 mm
3.6 mm
Main Display Character Size
The K3GN uses M3 terminals. A terminal
cover is provided.
Panel Cutout Dimensions
K3GN
• For installation, insert the K3GN
panel into the rectangular hole,
insert the adaptor from the rear, and
push it in to reduce the gap between
the panel surface and the adaptor.
Secure the Unit with the screws.
For water-proof installation, insert
the rubber gasket onto the body of
the K3GN.
• If multiple mounted Units are used,
make sure the ambient temperature
for the K3GN does not exceed the
specified temperature.
1
2
24 VDC
5.8 mm max.
5.8 mm max.
Input range
Input
terminals
DC voltage/DC current
4 to 20 mA
E
-
F
1 to 5 V
D
-
E
±
5 V
±
10 V
No-voltage contacts and NPN open collector
(Models with NPN inputs)
B
-
C
No-voltage contacts and PNP open collector
(Models with PNP inputs)
A
-
C
Be sure to read the Precautions for Correct Use and other information required when using the K3GN in the
following user’s manual.
K3GN Digital Panel Meter User’s Manual (Cat.No. N102)