10
H7CZ
Operating Procedures
Setting Procedure Guide
Run mode
Power ON
Function
setting mode
Note:
Displayed only when the output mode is C, R, K-1, P, Q, or A.
3 s min.
*
2
3 s min.
*
1
Change to Function Setting Mode.
Input mode
(CNTM)
Output
time
(OTIM)
Output mode
(OUTM)
(1 ms)
(20 ms)
(No decimal
point)
Prescale
value
(PSCL)
Counting
speed
(CNTS)
(30 Hz)
(5 kHz)
The characters displayed in reverse video are the default settings.
(N)
(F)
(C)
(R)
(K-1)
(P)
(Q)
(A)
(DOWN)
(UP)
(99.999)
(1.000)
(0.001)
(0.50 s) (99.99 s)
(0.01 s)
To next page
From next page
Reset input
signal width
(IFLT)
Decimal
point position
(DP)
• Set the input mode using the
U
Key.
• Set the output mode using the
U
Key.
• Set each digit using the individual
U
Key.
• Set the counting speed using the
U
Key.
• Set the Reset input signal width using the
U
Key.
• Set the decimal point position using the
U
Key.
(One digit after
decimal point)
(Two digits after
decimal point)
(Three digits after
decimal point)
• Set each digit using the individual
U
Key.
Function Setting Mode
up
down
n
f
0.01
99.99
0.50
30hz
1ms
0.001
99.999
1.000
20ms
c
r
k
-1
p
q
a
*1.
If the mode is switched to the function setting mode during operation, operation will continue.
*2.
Changes made to settings in function setting mode are enabled for the first time when the mode is changed to run mode. Also,
when settings are changed, the counter is reset (present value initialized and output turned OFF) on returning to run mode.
For details on operations and display in run mode, refer to page 13.
The display depends on the selected configuration.
