14
8. Transferring the Data
You can transfer measurement data to a
Bluetooth
®
wireless technology device.
You can transfer up to 30 sets of stored measurement results for each personal profile number.
The content and display for the measurement results may vary depending on the application used to view them.
For details, refer to the manual provided with the application you are using.
Registering the Unit with the Destination Device (Pairing)
What is Pairing:
This refers to the procedure for registering the unit with the device so that it can be used to transfer data.
Pairing is required when a device is connected to the unit for the first time, or if the same device is used to
transfer data for a different personal profile number.
Follow the procedure below to pair the unit with the destination device.
Refer to “Transferring the Data” for information about transferring the data with a device that has already been
paired with the unit.
1.
Display the measurement results.
• Pairing (Registration) after taking a
measurement:
Follow the steps in Section 5, to display the
measurement results.
• Pairing (Registration) without taking a
measurement:
Follow the steps in Section 7, to display the
results for the last measurement.
• Pairing (Registration) when using GUEST
mode:
You can also register a device after taking a
measurement using GUEST mode.
Follow the steps in Section 5, to display the
measurement results.
2.
Enable pairing (registration) on the
device.
Set the application on the device ready for
pairing.
For details, refer to the manual provided with
the application you are using.
3.
Press the UPLOAD button for
2seconds or longer.
Use the application to pair the unit with the
device.
For details, refer to the manual provided with
the application you are using.
Note:
If you press the UPLOAD button
while pairing, pairing will be stopped
and the display will revert to the
previous screen.
If the pairing completes successfully, the “P”
indicator lights and the alarm will beep (Blip!
Blip!).
Notes:
• If the pairing process does not complete
within approximately one minute, it will end
without paring the unit with the device.
• If the pairing process does not complete
successfully, then the “Err” indicator lights
and the alarm will beep three times (Beep!
Beep! Beep!).
Check the application on the connected
device, then repeat the procedure from step
2 to try again.
HBF-206IT-E_A_M.book Page 14 Wednesday, March 10, 2010 12:04 PM