Omron 3G3MX2 Series, Connection Manual

Page: 15 / 34

7. Connection Procedure
2
After turning ON the power
supply, the panel displays as
shown on the right.
Use the procedure on the right
to set the parameter.
[A001] Frequency Reference
Selection 1: 04
[A002] RUN Command
Selection 1: 04
*Set "04" (optional board).
*When the power supply is
turned ON, the data of d001
(Output frequency monitor) is
displayed.
(In the case of factory default
value)
0 0.00
a001
a0 02
04
a001
a002
02
a0 04
a002
Press the Increment Key two times.
Press the Enter Key.
Press the Increment Key once.
A002 parameter is displayed.
The parameter is displayed again.
Press the Enter Key.
Change the data to "04".
The initial data is displayed.
The parameter is displayed again.
Press the Enter Key.
Change the data to "04".
Press the Increment Key twice.
The initial data is displayed.
Press the Enter Key.
A001 parameter is displayed.
Press the Mode Key 3 times.
After turning ON the power
supply, the panel displays as
shown on the left.
13