21
•
EN
Setting up a Bluetooth connection with mobile devices
Press the MODE button (repeatedly) until the display indicates “
BLUE
“. The audio player will enter the pairing
mode. Now activate the Bluetooth function at the Bluetooth source and start the device scan. Select
“
OMNITRONIC
“ from the list and connect the devices. Then play music at the Bluetooth source as you
normally would. You can operate the Bluetooth source with the remote control, too.
USB devices and memory cards
Insert a USB device into the USB port and/or a memory card into the card slot. The display indicates “
USB
“
or “
SD
“. After loading a data carrier, it is selected as the playback medium and the playback will start
automatically. Use the remote control to operate the music conveniently from a distance.
Tuner mode
The button [►
] starts the automatic station memory (or U/SD on the remote Control). The automatic
station memory will be running forward and stores stations with good reception. Stored stations can be called
with the buttons [
] and [
]. For direct selection of a station use the numerical keys [0-9] on the remote
control.
Remote control
When actuating a button, always direct the remote control towards the sensor. There must be no obstacles
between remote control and the sensor.
Button
Function
Audio player on/off
MODE
Switches between USB/SD/Bluetooth/FM tuner
Mute
►
Play/pause
/
Short actuation: previous/next title or station
Long actuation: fast rewind/forward
EQ
Equalizer settings
Vol-/Vol+
Volume down/up
RPT
Repeat functions one/all
U/SD (SCN)
Automatic station memory
0-9
Direct title or station selection
Notes
•
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the foil
from the battery support on the rear side of the remote control. Otherwise operation of the remote control is not
possible.
•
If the range of the remote control decreases, replace the battery. For this purpose, on
the rear side of the remote control press the small bar with the groove to the right and
at the same time remove the battery support. For operation, one 3 V button cell type
CR 2025 is required. When inserting, pay attention that the positive pole of the button
cell shows upwards in the support.
•
Remove the battery from the remote control as a precaution if the device is not used for a longer period of time.
Summary of Contents for EP-220PS
Page 1: ......
