18
If the +/- 10 % LED is lit:
• Watch the dotted lines on the platter's edge. The numbers next to the strobe-lamp correspond to the play-
back-speed adjusted via the Pitchfader.
Should the dots of the upper line seem to be standing still, the playback-speed is +7,2 %,
should the dots of the second line seem to be standing still, the playback-speed is +3,3 %,
should the dots of the third line seem to be standing still, the playback-speed is 0 %,
should the dots of the lowest line seem to be standing still, the playback-speed is -3,3 %,.
• If you wish to set the speed to 45 RPM, press the 45-button. If you wish to set the speed to 78 RPM,
simultaneously press the 33-button and the 45-button.
Main Tempo-function:
If the original pitch should be maintained although the playback-speed is adjusted, press the Auto Pitch
Correction-button.
D) Adjusting the rotation-direction:
After turning the unit on, the platter moves forwards and the green LED is illuminated. You can reverse the
rotation-direction by pressing the Direction-button (red LED is illuminated).
8. OPERATION
• Select the speed required for the record you want to play.
• Put the record on the platter. Use the puck if needed (e.g. for singles).
• Remove the the stylus cover and release the tonearm.
• Press the START/STOP-button and the turntable begins to rotate.
• Set the tonearm lift to the up position and move the tonearm to the desired starting position. Under
insufficient lighting conditions use the target light for spotting the exact starting position.
• Set the tonearm lift to the down position and the tonearm slowly lowers to the record.
• Should you desire to stop the turntable without removing the tonearm from the record, simply press the
START/STOP-button. The electro-brake will immediately stop the rotation.
• Should you desire to interrupt playback for a short period, set the tonearm lift to the up position. When you
wish to continue playback, set the tonearm lift back to the down position.
• When you do not need the tonearm lift at all, leave it in the down positon.
9. EXCHANGING THE PICK-UP SYSTEM
Loosen the tightening screws on the headshell and remove the connection-cables of the pick-up system.
Remove the old pick-up system from the Headshell.
Read the user manual of the new pick-up system.
Put the stylus cover on the stylus.
Connect the Headshell's connection cables with the terminals of the pickup-system and make sure that the
occupation of the cables is correct.
The different colours mean:
Used colour:
Channel and poles:
White (L+)
Left, plus-pole
Blue (L-)
Left, minus-pole
Red (R+)
Right, plus-pole
Green (L-)
Right, minus-pole
Tighten the screws on the Headshell.
Adjusting the overhang:
The overhang is the distance between the stylus and the center of the turntable.
For optimized pick-up, the overhang should be set to 20 mm.
