15
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
The RCA-connection plugs must never be connected with the Phono-inputs of your mixer!
CAUTION!
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
Never remove the serial barcode from the device as this would make the guarantee void.
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.
4. INSTALLATION
Install the turntable on a plane, stable ground.
Place the platter on the holder. Please note that the platter is fixed on the holder via an extremely powerful
magnet. Place the slipmat on the platter.
Remove the hinges from the bottom side of the styrofoam. Install the dust-cover on the two hinges.
Remove the headshell from the cartridge holder and install your pick-up system.
Installing the pick-up system
Read the user manual of the pick-up system.
Put the stylus cover on the stylus.
Connect the Headshell's connection cables with the terminals of the pickup-system and make sure that the
occupation of the cables is correct.
The different colours mean:
Used colour:
Channel and poles:
White (L+)
Left, plus-pole
Blue (L-)
Left, minus-pole
Red (R+)
Right, plus-pole
Green (L-)
Right, minus-pole
Tighten the screws on the Headshell.
Adjusting the overhang:
The overhang is the distance between the stylus and the center of the turntable.
For optimized pick-up, the overhang should be set to 20 mm.
Loosen the tightening screws on the headshell and move the system forwards or backwards until you reach
the desired position.
Make sure that you tighten the screws before you operate the device again.
