Page 21
Use the
lr -s
command to display the link redundancy configuration.
> lr -s
Link redundancy: disabled
Return to primary: disabled
Working port: F1
Status: not active
Link: no link
Protection port: F2
Status: not active
Link: no link
>
To enable link redundancy and configure the link not to return to the primary link when the link failure has
been fixed, use the
lr -ena -noret
command.
> lr -ena -noret
NOTE: To enable link redundancy using the CLI, the on-board DIP switches must be disabled. Use
the
switch -dis dipsw
command to disable the DIP-switches.
Use the
lr -s
command to display the link redundancy configuration.
> lr -s
Link redundancy: enabled
Return to primary: disabled
Working port: F1
Status: active
Link: no link
Protection port: F2
Status: not active
Link: no link
>
