5. Installation instruction and calibration
12.
Indoor installation: As shown in the picture,
place the product so that the blue line on
the monitor is placed at the point where the
virtual red lines cross and fix it with the angle
adjusting bolt.
13.
Outdoor installation: First park the car in
an even, open place with no big obstacles
such as tall buildings. As shown in the
picture, place the product so that the blue
line on the monitor is placed on the
horizontal line (the point where the virtual
red lines cross) and fix it with the angle
adjusting bolt.
Artificial
Line
Horizont
al Line
Horizontal
Line
14
14.
After step 12, drive the car outside the
building and wait for about 5 minutes until
GPS reception is completed. Then, a voice
message explains that GPS reception has
been completed. After step 13, just wait at
the spot for GPS reception. When the GPS
reception is completed, drive the car to
calibrate the product.
15.
Drive for at least one minute over 30km/h on
a straight road with clear, continuous lines
(regardless dashed or not) on it, then a voice
message will say “ The Lane Departure Warning
System has been calibrated. ” After the message,
all functions will operate normally.
While waiting for the GPS reception, set the car
type. For details, refer to page 10 in this manual.
Also set volume, TTC, working speed, etc.
Summary of Contents for K11
Page 42: ...www omnikine co kr ...