L-1633 Rev. 3
© OmniGuide, Inc.
Page 33
Figure 10-3
Home Screen
10.3.1.
Manual Controls
The manual control button brings you to the Laser output control screen, allowing you to set and
fire the Laser. A default Laser setting will be shown when first entering the manual control
screen. The user can increase or decrease the pulse duration, flow, and power by pressing the up
and down arrows above and below the corresponding parameter that needs to be changed. The
user can change the mode of operation by pressing the corresponding waveform on the left most
part of the screen and the selection will be highlighted. In Figure 10-4, user chose single pulse
and that selection is highlighted. Since the user did not press the superpulse button, the Laser is
at CW. The user also has the choice save the existing setting under a specific surgeon preset by
pressing the icon.
&3@G3>
A@FDA>E
+GD97A@
)D7E7FE
;47D)D7E7FE
35=
!A?7
%3E7D%A9
+7FF;@9E
.A>G?7
*736K+F3@64K
GFFA@
