11. Install the two threaded compression fittings in the Filter
Housing. See Figure 7.
12. Screw the fittings into the “IN” and “OUT” ports of the filter
housing. Use a wrench and tighten the two fittings into the filter
housing head.
NOTE:
The “IN” and “OUT” ports are marked on
the top of the filter housing.
13. Install the filter assembly onto the mounting screws installed in
step 2 and tighten the mounting screws. See Figure 8.
Finish Connecting the Tubing; See Figure 9.
14. Connect one piece of the plastic tubing from the “IN” port of the
filter housing to the saddle valve inlet port. To connect the tubing:
a. Slide the brass compression nut over the end of the poly
tubing.
b. Slide the white plastic compression sleeve over the plastic
tubing and into the compression nut.
c. Slide the brass insert into the plastic tubing.
d. Screw the tubing assembly onto each of the ports as illustrat-
ed in Figure 9.
15. Connect the other piece of plastic tubing from the faucet stem
to the “OUT” port of the filter housing.
Turn on the Water
16. Open the filter faucet and then slowly open the cold water shut
off valve.
17. To remove the air from the filter run the water for 30 minutes or
until the water runs clear.
NOTE:
Some trapped air may exist for the first few days of
operation.
18. Check for leaks at all the fittings.
For further operating, installation, or
maintenance assistance:
Call Omnifilter Customer Service
at 800-937-6664
3
3/8" x 1/4"
Compression
Fitting
Outlet Port
3/8" x 1/4"
Compression
Fitting
Inlet Port
Figure 7
Figure 8
Faucet Stem
Compression Nut
Plastic Sleeve
Brass Insert
Plastic Sleeve
Brass Insert
Inlet Port
Compression
Fitting
Assembly
(parts listed above)
Saddle Valve
Inlet Port
Outet Port
Figure 9
System Tested and Certified by NSF International
against ANSI/NSF Standard 42 for the reduction of
Chlorine Taste and Odor, and against ANSI/NSF
Standard 53 for the reduction of Mercury, Cyst, Lead,
VOC’s, Asbestos, Lindane, and Atrazine.
