© 2010 Omnicell, Inc.
OmniTT/AnesthesiaTT Installation and Service Guide
/
67-2024 Rev D
1-1
Electronics Tray
Introduction
This section will give detailed instructions on the proper way to replace specific parts within the
CT PC Sled, also known as the electronics tray. To complete any of these procedures, first ensure
that the sled has been unplugged from any power outlet.
Tools List
The following tools are required to install the Electronics Tray:
T8 Torx Driver
T10 Torx Driver
T15 Torx Driver
9/64” Allen wrench
Removal Procedure
LCD Screen
1. Perform a graceful shutdown of the electronics tray.
2. Remove the four outer
that secure the LCD bezel to the cabinet.
Use a Torx T10 screwdriver.
Figure 1-1.
Remove the Four Outer Screws
3. Remove the
.
