© 2009 Omnicell, Inc.
OmniTrack Installation Guide/
67-2055 Rev A
OmniTrack Installation and Programming Instructions
1-5
Programming the OmniTrack
4. Insert the controller cover plate into the outermost groove on the extrusion.
Figure 1-7.
5. Test the brackets to ensure that they fit snugly against the extrusion.
Programming the OmniTrack
The OmniTrack functions in the same manner as standard OmniSupplier switchpanels.
Programming the OmniTrack, however, is somewhat different. Please follow the instructions
below to program your OmniTrack:
Set Programming Mode
1. Power on the cabinet.
2. Set the OmniTrack into programming mode by pressing and holding down the upper left
Return Item
button for approximately ten seconds until the bottom row LEDs light up.
Figure 1-8.
In programming mode, the OmniTrack LEDs represent the following:
Row One
: Zone address
