© 2009 Omnicell, Inc.
OmniTrack Installation Guide/
67-2055 Rev A
OmniTrack Installation and Programming Instructions
1-9
Configuring the OmniSupplier Software
Exit Programming Mode
Press any of the items in the bottom row (row four) of the OmniTrack. This will turn OFF all of
the LEDs and exit programming mode.
Figure 1-15.
Configuring the OmniSupplier Software
For the most part, configuring the OmniSupplier for OmniTrack is done just like shelf
configuration. After the OmniTrack controller is programmed and the unit is installed in the
OmniSupplier, it acts just like a regular switchpanel. Items are addressed as usual.
Pre-select
works if the OmniTrack is programmed as a supply drawer.
Special Considerations:
OmniTrack with SecureTrack
Create an extra cabinet with zone "9" and doors activated. The OmniTrack controller talks to the
SecureTrack controller and opens the SecureTrack doors when items are selected. (Enable a
second cabinet with zone 9 active).
OmniTrack with Pharmacy Zone
Program the zone in which the OmniTrack is located for pharmacy and assign drugs as usual.
Example Configuration
For the configuration shown in the illustration below, the OmniTrack would be programmed as
follows:
Zone 4
Host Zone 4
Button#
1
2
3
Binary Value
1
2
4
off
off
off
= button number range 40-71
ON
off
off
= button number range 72-103
off
ON
off
= button number range 104-135
ON
ON
= button number range 136-167 NOT VALID
off
off
ON
= button number range 168-199 NOT VALID
